Make The Open terminator, not much to this just use one SMA male connector. 3(Three) SMA male Crimp Plug Connector For RG-58ģ. You can buy a ready made calibration standard, in my case one was not available when I purchased the miniVNA Pro. Note: To charge battery power On, charge light will go Off when fully charged. ![]() Note: Power On to USB side Off to RJ11 side. ![]() Note: The miniVNA Pro is shipped with battery disconnected. Note: The On/Off switch is used to Charge battery and run the miniVNA Pro on wireless. Note: Make sure all the JAVA file are up-to date. Note: To make diver installation easier, I download the executable driver files. If you did not buy one you can make your own. The first thing that need to be done in vna/J is, Analyzer Setup. Launched vna/J and all worked without any issues. Now that the PC sees the miniVNA Pro, I downloaded vna/J software from the DL2SBA website. ![]() Start-Control Panel-Hardware and Sound-Devises Manager-Ports(COM & LPT)-USB Serial Port(COMxx) Get the miniVNA Pro COM Port Win7 圆4 Professional:Ģ. Start-Control Panel-Hardware and Sound-Devises and Printers-Unspecified-FT232 USB UART I then went back to the the FTDI website and downloaded the No Longer Supported 圆4 FTDI driver for windows* and gees what that work just fine.ĭid windows find the miniVNA Pro Win7 圆4 Professional:ġ. Luckily I always create system restore point before installing any new drivers, after trying everything to get the latest FTDI driver to work, I restored the system back to the last saved system restore point. Like always the first issue when installing new hardware / software on a windows PC are the drivers and like always on a windows PC the latest driver did not work.Īfter installing the latest 圆4 FTDI driver for windows*, I connected the miniVNA Pro to the USB cable and like always on a windows PC it did not work. The Experiment: In this experiment were going document my installation notes for the miniVNA PRO.
0 Comments
Leave a Reply. |